The Pothole Process

Here's what happens when a pothole appears in the borough.

1. The resident sees a defect on the road.

2. The resident goes on the Hounslow Highways website and reports the defect here. When reporting, please include:

  • Give the exact location (closest house number or other defining features on the road) as well as pinning on the map.
  • Please include a photo of the defect.

 

Highways inspector

3. Depending on the severity of the defect, a Highways inspector will attend site within 1 and 3 business days. If the defect requires immediate action, a temporary repair will be carried the same day and a permanent job will be raised within 28 days.

4. Once a job/instruction has been raised the Hounslow Highways Operational Hub assign this to a crew's tablet device and this is programmed for either 28 or 56 days (depending on the defect).

Repair crew

5. Crew arrive on site and check the defect against their job order on their tablet. The crew also check it is safe for them and the public to carry out the works and also ensure the defect is accessible.

Traffic sign

6. Crew place out traffic management for safety (road signs / diversion signs and barriers if necessary).

Recording the defect

7. Crew take a "before" photo on the tablet for recording purposes.

Recording the defect

8. Crew take out the equipment and retrieve the cable locator (CAT & Genny) to establish if there are any underground services.

Cutting a square repair area

9. Crew use the 'abrasive wheel' to cut a neat square area which is larger than the pothole itself. During this process, there is a water dust suppressant system to ensure minimal dust is created.

Excavating the damaged area

10. Crew use a 'compressor breaker' to excavate the damaged area. They also use a shovel and tape measure to make sure that the area is the correct depth. This is then sprayed with sealant which helps to combine the new and old materials to ensure a weather proof seal.

Using the wacker plate

11. Once the excavation is complete, the crew place a layer of asphalt into the hole. Then it is compressed with a 'wacker' plate to ensure the layer is level before adding further layers. The crew then spray water over the area to lower the temperature before they add the next layer.

First layer completed

This is after the first layer has been completed.

Completed pothole repair

12. The process is repeated with the next layer (sometimes the second layer is the final layer depending on the depth). With the final layer, the pothole is overfilled with asphalt to enable a good compaction and an even finish.

Once the crew have finished, they take an "after" photo for recording purposes and an automated closure notice is sent to the person who raised the enquiry.

The crew also remove all traffic management and tools are to leave the area clear and tidy.



Cookies on the Hounslow Highways website

We use cookies and similar technologies on our websites to help provide you with the best possible experience. By using our sites and apps, you agree that we may store and access cookies and similar technologies on your device. I understand (close this notice)
You can find out more in our Cookies Policy.